| 提交詢價信息 |
| 發布緊急求購 |
價格：電議
所在地：北京
型號：HD-825
更新時間：2020-03-05
瀏覽次數：2020
公司地址：北京市昌平區建材城西路87號
張浩(先生) 銷售經理
| 產品名稱:細菌計數板 規格型號:HD-825 |
Bacteria Counting Chamber is a one piece construction ensuring durability and accuracy with a Thoma ruling on a single round plateau. The Bacteria Counting Chamber is used for bacteria and sperm counting. Cell Depth is 0.02mm. Usage Bacteria/Sperm Counts Cell Depth 0.02mm +/- 1% (1/50mm) Volume of 1 Square mm 0.02 Microliter Ruling Pattern Thoma, 1/400 Square mm Rhodium coated (bright-line) No Counting Technique : Thoma Counting assumes precise knowledge of the limit lines of the counting chambers used. These are shown in the illustration below. Each one of the small squares is 0.05 x 0.05 mm square, ie 1/400 mm2. This figure will be found printed onto the surface of the counting chamber. To ensure that cells which are on or along the limit lines are not counted twice or are not missed during the count, certain rules have to be observed (see illustration below – this illustration is for an Improved Neubauer, hence the triple lines, but the principle is the same for the Thoma).
The black cells are the ones which would be included in the count for that square, the white ones would not as they will be included in the count for the adjacent squares. The count should be started at the top left-hand corner and follow the direction shown by the arrow (see illustration). Counting may be enhanced with the microscopes illumination reduced.
Notes on Counting Use reduced microscope illumination for all chambers.
The difference of the counter cells in the large squares and the group squares must not exceed 10 cells. Double checks must be performed for all cell counts. After
counting the two counting nets the bottom counting net is to be counted in the same way as a check. When doing this it is to be ensured that the chamber has not dried out. This can be prevented by filling the bottom chamber only shortly before the count and not counting after the sedimentation time.
The difference between the totals of the counts for the two counting nets must not exceed 10 cells. The average value of the counts is then used in the calculation formula or multiplied by the corresponding factor.
計數板的使用
準備
準備計數時，磨光的表面小心地用擦鏡紙擦干凈。蓋玻片也要擦干凈。
蓋上蓋玻片在需要蓋的周邊區域需要用蒸餾水弄的微濕然后蓋玻片要慢慢的從計數板的前端推入，直到蓋玻片的前端邊緣與計數板的劃格子的區域處于同位。
注意：蓋玻片是很容易壞掉的！
在外部支持和蓋玻片之間的干擾線（牛頓環）的組成顯示了蓋玻片的準確位置。
計數板加樣
取一個良好混合型的吸管并且放置一些初期的幾滴液體。
把吸管的外部擦干然后保持吸管一定的角度直到小滴液體被吸管吸上去。然后這滴液體被放置在蓋玻片和計數板之間。由于蓋玻片和計數板之間的毛細管現象作用的結果，兩個平面之間的縫隙被灌滿。在溶液要滿出擊數板截面的邊緣之前，馬上移走吸管的。如果有可見氣泡或者液體已經滿出邊緣并且進入其他的溝里，那么計數板就要擦干凈并且重新加樣。
計數
裝載好的計數板被放置在顯微鏡臺上然后計數格在低倍鏡焦距中顯示。高倍物鏡要非常小心的操作，因為計數板比常規的要更厚。如果你不小心的話，會導致計數板或者物鏡鏡頭的損傷。
如果可能的話，在作血細胞計數的時候使用機械平臺的顯微鏡。顯微鏡的照明是重要的，太亮了會影響劃格線的觀察。光可以通過虹膜光圈減弱直到劃得格子在背景中再次清晰可見。細胞/質粒的計數應該充分稀釋到他們不再互相重疊，并且均勻的分配。
要完成計數檢測需要擴大到期望的可見的細胞/質粒。細胞數量的計算推薦計數100方格作為排除少量的結果。
計數格在超過劃線區域使用時需要均勻的分配，并且這個通過藉由三倍之數決定的方格支架在進入區段之內。
計數完100方格后總數除100（計數的方格數），來得到每格的平均值。乘稀釋度，除1/4000（每個小方格的立方容積1/20 x 1/20 x 1/10 – 1/4000mm3）。這次計算得到的數字是原非稀釋流質的每立方毫米的細胞數量。
免責聲明：以上所展示的[HD-825 細菌計數板]信息由會員[北京杰瑞恒達科技有限公司]自行提供，內容的真實性、準確性和合法性由發布會員負責。
