| 提交詢價信息 |
| 發布緊急求購 |
價格：電議
所在地：上海
型號：SyrinTEC
更新時間：2014-12-31
瀏覽次數：812
公司地址：上海市徐匯區漕寶路80號D座
陳小姐(女士) 行政
Using the SyrinTEC enables treatment of the entire outside surface without any inside treatment, which would increase friction on the inside barrel and cause the plunger to drag when used.
The purpose of surface treatment of polymer-based materials is to increase surface wettability through electrical discharge. The low surface energy of polymer-based substrates often leads to poor adhesion of inks, glues and coatings.
To obtain optimum adhesion, it is necessary to increase the surface energy of the substrate to just above that of the material to be applied. Surface treatment with corona results in improved surface adhesion properties. SyrinTEC is specially designed for optimizing the adhesion properties of printing inks onto syringe barrels which are normally made of low surface energy polymer material such as PP, PE and others.
SyrinTEC uses highly durable ceramic electrode elements resulting in complete and uniform treatment of the syringe barrels. The SyrinTEC is available both as a standard unit in a low and high speed configuration for integration into existing printing lines customised units are available for specific printing machines.
| FEATURES: | |
| Easy to install and use | Connect to mains power and compressed air. |
| Fast treatment times | High power impact enables treatment times from 20-180 seconds, depending on material. |
| Standard or customised chambers | Chamber and drum size can be designed to most applications. Many available as standard. |
| Vacuum level | The plasma discharge is active from 1-4 mbar depending on application. |
| Process gas | Process gasses such as oxygen and argon can be used, but in mostcases it is not necessary. |
| Process control | The entire plasma process is controlled by the HV-X generator and PLC unit. All parameters are displayed through the touch panel. (Standard – Proface). |
| Cost efficient surface treatment | Due to the low power and no need of special treatment gasses the unit is a very cost efficient solution for improving surface wettability and adhesion. |
| Vacuum pressure plasma | Enables treatment of both conductive and non-conductive surfaces. |
| Technical Specifications | RotoVAC Vacuum Plasma Treater |
| Mains voltage and frequency | 230 VAC or 480 VAC 3Ph. |
| Output voltage/plasma power | Max. 400 Vp/max. 2000 Watt |
| Power supply | HV-X plasma generator series |
| Compressed air inlet | 5–6 bar dry and clean |
| Process gas | Standard: air, oxygen, argon, nitrogen on request |
| Vacuum pump capacity in m³/min. | 15 to 240 m³/min., depending on size of vacuum chamber |
| Vacuum level | 1–4 mbar |
| Evacuation time, typical | 15-60 seconds, depending on chamber size and pump capacity |
| Plasma treatment time, typical | 20–180 seconds, depending on material |
| Control and connectivity | Complete with touch panel. (Standard – Proface) |
| Regulation compliance | CE – RoHs – WEEE |
免責聲明：以上所展示的[SyrinTEC 丹麥Tantec公司]信息由會員[必和國際貿易（香港）有限公司]自行提供，內容的真實性、準確性和合法性由發布會員負責。
